Garmin GWS 10 Marine Wind Sensor Referensi Teknis - Halaman 8

Jelajahi secara online atau unduh pdf Referensi Teknis untuk Sistem GPS Kelautan Garmin GWS 10 Marine Wind Sensor. Garmin GWS 10 Marine Wind Sensor 42 halaman. Marine sensor
Juga untuk Garmin GWS 10 Marine Wind Sensor: Panduan Petunjuk Instalasi (43 halaman), Panduan Petunjuk Instalasi (44 halaman), Informasi Keselamatan Penting (48 halaman), Panduan Konfigurasi (2 halaman), Pernyataan Kesesuaian (1 halaman), Instruksi Instalasi (42 halaman)

NMEA 2000 Fundamentals

Linear Backbone Construction

Use the NMEA 2000 T-connectors to construct your NMEA 2000 backbone, and extend the backbone with appropriate lengths of backbone

cable if necessary. Use one T-connector per device. Use the sides of the T-connector to construct the backbone of the NMEA 2000 network, and

use the top of the T-connector to attach a NMEA 2000 device. By using only the sides of the T-connectors to construct the backbone, you create

a linear construction to your NMEA 2000 network. T-connectors can be separated by backbone cables or connected directly together.

Although the male and female connectors on the T-connectors and backbone cables will fit on all sides of a T-connector, it is very important to

use the top of the T-connector only to attach NMEA 2000 devices, not to attach other T-connectors or backbone cables.

To NMEA 2000 devices

and power

Female

terminator

Male

Backbone extension cable

terminator

Correct Linear Backbone Construction

To NMEA 2000 devices

and power

T-connector

installed incorrectly

Male

terminator

Male

Backbone extension cable

(also installed

terminator

incorrectly)

Incorrect Linear Backbone Construction

Technical Reference for Garmin NMEA 2000 Products