Garmin FUSION Apollo MS-WB670 Panduan Pemilik - Halaman 12
Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Kelautan Garmin FUSION Apollo MS-WB670. Garmin FUSION Apollo MS-WB670 44 halaman. Marine hideaway stereo
Juga untuk Garmin FUSION Apollo MS-WB670: Panduan Petunjuk Instalasi (19 halaman)
Halaman Cetak
Disabling the Loud Setting for a Zone
The LOUD setting maintains frequency response at low volumes and increases perceived loudness at high
volumes. This setting is enabled by default in all zones.
1 Select
> AUDIO.
2 Select a zone to adjust.
3 Select LOUD to clear the check box.
Adjusting the Gain for an Auxiliary Device
You can adjust the gain for a connected auxiliary device to achieve a volume level similar to that of other media
sources. You can adjust the gain in 1 dB increments. You can also adjust the gain for digital sources using an
optical audio connection.
1 Select an auxiliary source.
2 Select an option:
• To increase the gain, select
• To decrease the gain, select
NOTE: To achieve the best audio quality when using a portable media player with headphone output, it may
be necessary to adjust the volume control on the media player, instead of adjusting the gain.
Speaker Zones
You can group speakers in one area into a speaker zone. This enables you to control the audio level of the
zones individually. For example, you could make the audio quieter in the cabin and louder on deck.
You can set the balance, volume limit, tone, subwoofer frequency, and name for each zone, and configure
other zone-specific settings
DSP Settings
This stereo features digital signal processing (DSP). You can select pre-configured DSP settings for Fusion
speakers and amplifiers to optimize audio reproduction in their installed locations.
All DSP settings are configured using the Fusion-Link
Control App, page
31).
Configuring the DSP Settings
You must download and install the Fusion-Link remote control app on your compatible Apple
device before you can configure the DSP settings
You can configure the DSP settings to optimize the sound on each zone with the installed speakers, amplifiers,
and environment.
1 From the settings menu on your Apple or Android device, connect to the stereo using Bluetooth technology,
or connect to the same wireless network as the stereo.
2 Open the Fusion-Link remote control app on your compatible Apple or Android device.
3 If necessary, select the stereo you want to configure.
4 Select
.
5 If necessary, select the MUSIC tab.
6 Select a zone.
7 Select DSP SETTINGS.
8 Configure the DSP settings as needed, depending on the models of Fusion speakers and amplifiers
connected to the zone.
9 Repeat these steps for each zone.
10 After you have finished configuring the DSP settings for all zones, select an option:
• On an Apple device, select
• On an Android device, select
6
.
.
(Speaker Zone Settings, page
(Fusion-Link Wireless Remote Control App, page
> SEND DSP SETTINGS
> Zone > SEND DSP SETTINGS.
24).
™
remote control app
(Fusion-Link Wireless Remote
®
or Android
™
31).
Audio Control