AEG F55210VI0 Panduan Pengguna - Halaman 14
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin pencuci piring AEG F55210VI0. AEG F55210VI0 20 halaman.
Halaman Cetak
14
www.aeg.com
Problem and alarm code
The appliance does not drain the wa-
ter.
Once you have checked the appliance,
set and start the programme again. If the
problem occurs again, contact an
Authorised Service Centre.
For alarm codes not described in the
table, contact an Authorised Service
Centre.
9.2 The washing and drying results are not satisfactory
Problem
The dishes are not clean.
Scale particles on the dishes. The salt container is empty.
There are streaks or milky
stains on glasses and dishes.
Possible solution
• Make sure that the drain hose is correctly con-
nected.
• Make sure that the filters in the appliance are
clean.
• Make sure that the kitchen sink drains correct-
ly.
The necessary information for the Service
Centre is on the rating plate. record this
information:
• Model ......................
• Serial number (SN.) ......................
Possible cause
The selected programme
was not applicable for the
type of load and/or for the
degree of soil.
The basket was not loaded
correctly, water did not
reach all surfaces.
The spray arm could not turn
freely because of the incor-
rect arrangement of the
load.
The filters are clogged.
The filters are not correctly
assembled and installed.
The quantity of detergent
was not enough or no deter-
gent was used.
The cap of the salt container
is not closed correctly.
The level of the water soft-
ener is too high.
Possible solution
Make sure that the pro-
gramme is applicable for the
type of load and/or for the
degree of soil.
Load the basket correctly.
Make sure that the spray arm
can turn freely before you
start a programme.
Make sure that the filters are
clean.
Make sure that the filters are
correctly assembled and in-
stalled.
Make sure that a correct
amount of detergent is used.
Fill the salt container with
specific salt for dishwashers.
Make sure that the salt con-
tainer is correctly closed.
Set the water softener to a
lower level.