Garmin GHP 10V Panduan Petunjuk Instalasi - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Peralatan Kelautan Garmin GHP 10V. Garmin GHP 10V 20 halaman. Marine autopilot system
Juga untuk Garmin GHP 10V: Panduan Petunjuk Instalasi (48 halaman), Panduan Pemilik (28 halaman), Panduan Petunjuk Instalasi (20 halaman)
Halaman Cetak
nMEa 2000 Cables and Connectors
The NMEA 2000 cables connect the CCU and the GHC 10 to the
NMEA 2000 network. Either connect the CCU and the GHC 10 to an
existing NMEA 2000 network using the included T-connectors and drop
cables, or use all of the included NMEA 2000 cables and connectors to
build a NMEA 2000 network on your boat if needed
➊
➋
➌
NMEA 2000 drop cable, 6 ft. (2 m) (×2)
➊
NMEA 2000 power cable
➋
NMEA 2000 T-connector (×3)
➌
NMEA 2000 terminator, male
➍
NMEA 2000 terminator, female
➎
nMEa 2000 Extension Cables
NMEA 2000 extension cables are available if needed. Contact
your local Garmin dealer or Garmin Product Support for ordering
information.
4
(page
9).
➍
➎
tools needed
• Safety glasses
• Drill and drill bits
• 3
/
in. (90 mm) hole saw
1
2
• Wire cutters/strippers
• Phillips and flat screwdrivers
• Cable ties
• Waterproof wire connectors (wire nuts) or heat-shrink tubing and a
heat gun
• Marine sealant
• Portable or handheld compass (to test for magnetic interference
when determining the best location to install the CCU)
• Anti-seize lubricant (optional)
NOTE: Mounting screws are provided for the GHC 10 and the CCU. If
the provided screws are not appropriate for the mounting surface, you
must provide the correct types of screws.
GHP 10V Installation Instructions