Garmin GMR Fantom 56 Panduan Petunjuk Instalasi - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Peralatan Kelautan Garmin GMR Fantom 56. Garmin GMR Fantom 56 19 halaman.
Juga untuk Garmin GMR Fantom 56: Panduan Pemilik (12 halaman)
Installation Procedures
Preparing the Radar Mounting Surface
Before you can mount the radar, you must choose a suitable mounting location
page 2).
1 Secure the included mounting template to the surface at the mounting location, along the bow-stern axis, as
indicated on the template.
2 Drill the mounting holes using a 15 mm (
3 If you need to run the power and network cables through the mounting surface, select a location along
the center channel indicated on the template, drill a pass-through hole for the cables using a 32 mm
1
(1
/
in.) drill bit, and route the cables through the surface (optional)
4
page 7).
4 Remove the mounting template from the surface.
Mounting the Radar
Before you can mount the radar, you must select a mounting location
prepare the mounting surface
1 Place the radar onto the mounting surface, aligning the holes on the base of the radar with the holes you
drilled when preparing the mounting surface.
2 Apply the included Petrolatum Primer to the threads of the four threaded rods.
3 Insert the threaded rods
6 mm hex wrench.
To avoid damaging the pedestal, you should stop tightening the threaded rods when they no longer turn
easily.
4 From under the mounting surface, place the included plastic shoulder washers
and into the holes.
19
/
in.) drill bit.
32
(Preparing the Radar Mounting Surface,
through the mounting surface and into the radar base, and tighten them using a
(Mounting Considerations,
(Wiring and Connection Considerations,
(Mounting Considerations,
page 3).
over the threaded rods
page 2) and
3