Garmin GSD 22 Panduan Petunjuk Instalasi - Halaman 7
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Peralatan Kelautan Garmin GSD 22. Garmin GSD 22 8 halaman. Marine radio apparatus ( marine sounder)
Juga untuk Garmin GSD 22: Panduan Petunjuk Instalasi (11 halaman), Panduan Petunjuk Instalasi (10 halaman), Pernyataan Kesesuaian (1 halaman)
Halaman Cetak
Blink Codes
When the GSD 22 is installed, it switches on when the chartplotter is powered on. The two-color (green and red) LED on the GSD 22 indicates
the current operational status of the device.
Code
Green blinking, on for 1 second, off for 0.5 second (slow blink)
Red blinking, on for 1 second, off for 0.5 second (slow blink)
Solid Red (no blink)
Red blinking, on for 1/10 second, off for 1/10 second
(very fast blink)
S
pecifications
Physical
Size:
7 ⅝ in. L x 6 ⅛ in. W x 3 in. H
(19.3 cm x 15.5 cm x 7.6 cm)
Weight:
2.1 lbs. (953 g)
Case:
Fully gasketed, high-impact plastic and aluminum alloy, waterproof to IEC 529-IPX-7
Temp Range:
From 5°F to 158°F (from -15°C to 70°C)
Electrical
Source:
10-35 Vdc
Usage:
25 watts maximum
Fuse:
AGC/3AG - 3.0 A
Compass Safe Distance:
Sonar
Sounder Power: 500/1,000/2,000 watts (RMS) (Dependent on transducer type.)
4,000 /8,000/16,000 watts (peak to peak) (Dependent on transducer type.)
Frequency:
50/200 kHz
Depth:
5,000 ft. (1.524 km) maximum depth (Depth capacity is dependent on transducer type, water salinity, bottom type, and
other water conditions.)
Data Output
Source: Garmin Marine Network
5.9 in. (150 mm)
Status
GSD 22 is servicing one directly-wired connection and the chartplotter is
operating properly.
You should see sonar data on the chartplotter.
GSD 22 is powered on but is waiting to connect to a chartplotter. In this state,
the GSD 22 does not transmit any sonar signals or send any sonar information
to chartplotters. If a chartplotter is connected and this code persists, check the
wiring.
Software failure - Call Garmin Product Support. If the cause is a software error,
the chartplotter can show the error. Power must be cycled to clear the error.
System alarm. The chartplotter gives a message indicating the type of failure.
After the alarm condition is fixed, power must be cycled on the GSD 22 to clear
the alarm.
GSD 22 Installation Instructions