Garmin GHS 10 Panduan Petunjuk Instalasi - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Radio Kelautan Garmin GHS 10. Garmin GHS 10 10 halaman. Vhf 300 series
Juga untuk Garmin GHS 10: Panduan Petunjuk Instalasi (12 halaman), Panduan Petunjuk Instalasi (12 halaman), Panduan Petunjuk Instalasi (17 halaman)

Connecting a VHF 200 Series Radio to a NMEA 2000 network

The VHF 200 and VHF 200i radios can be connected to your existing NMEA 2000 network, or you can build a basic NMEA 2000 network

to connect to another NMEA 2000-compatible device, such as a chartplotter. For more information on NMEA 2000 and to purchase

required connectors, visit www.garmin.com.

Note: The VHF 100 and VHF 100i radios cannot be connected to a NMEA 2000 network. See

network.

To connect the VHF 200 series radio to your existing NMEA 2000 network:

1. Determine where you would like to connect the radio to your existing NMEA 2000 backbone.

2. Disconnect one side of a NMEA 2000 T-connector from the backbone at an appropriate location.

If you need to extend the NMEA 2000 backbone, connect an appropriate NMEA 2000 backbone extension cable to the side of the

T-connector you disconnected.

3. Add a T-connector (not included) for the radio in the NMEA 2000 backbone by connecting it to the side of the T-connector you

disconnected.

4. Route a NMEA 2000 drop cable (not included) to the bottom of the T-connector added in step 3 to your NMEA 2000 network. Use a drop

cable with a length up to 20 ft. (6 m).

5. Connect the drop cable to the T-connector and the NMEA 2000 port on the radio

CAUtIoN: If you have an existing NMEA 2000 network on your boat, it should already be connected to power. Do not connect an additional

NMEA 2000 power cable to an existing NMEA 2000 network, because only one power source should be connected to a NMEA 2000 network.

To create a basic NMEA 2000 network:

1. Connect two T-connectors (not included) together by their sides.

2. Connect a NMEA 2000 power cable (not included) to one of the T-connectors.

CAUtIoN: A NMEA 2000 power cable must be connected to a 12 Vdc power source through a switch. The VHF 200 series radio may drain your

battery if it is connected directly. Connect the cable to the ignition switch of the boat if possible, or through an appropriate additional switch.

3. Connect a NMEA 2000 drop cable (not included) to the other T-connector and to the NMEA 2000 port on the radio.

NMEA 000 port

Other NMEA

000 device

T-connectors

Connecting the VHF 200 Series Radio to an Existing NMEA 2000 Network

page 5

VHF 00 series

radio

NMEA 000

chartplotter

Drop cable

NMEA 000

backbone

VHF 100/00 Series Radio Installation Instructions

to connect your radio to a NMEA 0183