Garmin GTX 32 Panduan Instalasi - Halaman 24

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Radio Kelautan Garmin GTX 32. Garmin GTX 32 45 halaman.

1. Insertion/Extraction tools from ITT Cannon are all plastic; others are plastic with metal tip.

2. Non-Garmin part numbers shown are not maintained by Garmin and consequently are subject

to change without notice.

3. Alternate contacts for 18 AWG wire: As an alternative to the Positronic contacts listed (and

provided in the installation kit), the installer may use contacts made by ITT Cannon under P/N

031-1007-001. These contacts require the use of a different crimp tool positioner than shown

in the table, with the part numbers as follows: Daniels P/N K250, Astro P/N 616245, or ITT

Cannon P/N 980-0005-722.

4. Extracting the #16, #18 and #20 contact requires that the expanded wire barrel be cut off from

the contact. It may also be necessary to push the pin out from the face of the connector when

using an extractor due to the absence of the wire. A new contact must be used when

reassembling the connector.

5. For applications using 16 AWG wire, contact Garmin for information regarding connector

crimp positioner tooling.

6. All wires must be passed through the backshell before being assembled to connector.

3.3

Backshell Assembly

The GTX 32 connector kit includes one Garmin backshell assembly. Garmin's backshell connectors give

the installer the ability to quickly and easily terminate shield grounds at the backshell housing using one

of two methods available (SPIDER or Shield Block).

The SPIDER grounding method is permitted for previous installations; however Garmin

recommends the use of the Shield Block grounding method for all new installations.

Garmin Integrated Flight Deck Installations:

To assemble the backshell and grounding system, refer to instructions provided in the G1000 System

Installation Manual (190-00303-00), as well as the SPIDER Installation Instructions (190-00313-02) and

Shield Block Installation Instructions (190-00313-09).

Non- Garmin Integrated Flight Deck Installations:

GTX 32 installations that are not installed with the Garmin Integrated Flight Deck, the connector and

backshell assembly is shown in Figure 3-1. Refer to the SPIDER Installation Instructions (190-00313-02)

and Shield Block Installation Instructions (190-00313-09) for grounding instructions.

1. Backshell Cast Housing. Provides a mounting point for connector accessories.

2. D-Subminiature 25 pin connector.

3. Ground System (SPIDER ground shown). Allows shield grounds to be made to the backshell

housing.

4. Strain Relief Tab. Fastens wiring bundle to housing.

5. Backshell Lid. Provides access when servicing the connector.

Page 3-2

Revision F

NOTES

NOTE

GTX 32 Installation Manual

190-00303-60