Garmin Astro 220 Setup Manual - Halaman 3
Jelajahi secara online atau unduh pdf Setup Manual untuk Produk Perawatan Hewan Peliharaan Garmin Astro 220. Garmin Astro 220 6 halaman. Declaration of conformity
Juga untuk Garmin Astro 220: Panduan Memulai Cepat (2 halaman), Pernyataan Kesesuaian (1 halaman), Spesifikasi (2 halaman)
Halaman Cetak
Hold the unit
level and turn
slowly.
Allow the DC 20 to communicate with
➍
the Astro 220
The DC 20 is shipped from the factory already added to your
Astro 220 Dog List and the battery is charged to approximately
50% of full capacity, so you can use it immediately. Make
certain the VHF antenna is attached and snug.
1.
Observe the blinking red LED, indicating power is on.
After the DC 20 has initialized
(determined its GPS location)
the LED then double blinks.
2.
The Dog Tracker page
compass pointer points in the
direction of the dog and titles
it "Dog". The location updates
every 5 seconds.
Dog Status Icon
3.
To check for communication and good GPS signal
reception, while on the Dog Tracker page, press the
ENTER key on the Astro 220 to view the Dog Info page.
This page contains information about the dog such as:
name, state of activity (running, on point, treed, sitting, and
"unknown?" if no status can be determined), distance from
your location, distance traveled, and average speed. It also
provides data about the
LED blinks
DC 20 transmission update rate, unit ID,
red when
battery capacity, communication signal
power is on.
strength, and strength of the GPS signal
being received by the DC 20. Red bars
indicate a weak signal while green bars
DC 20
indicate a strong signal.
power
key
Dog's direction
from you
Dog's distance from you