AEG OKO FAVORIT 40660 i Petunjuk Pengguna - Halaman 38

Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Mesin pencuci piring AEG OKO FAVORIT 40660 i. AEG OKO FAVORIT 40660 i 44 halaman. Aeg dishwasher
Juga untuk AEG OKO FAVORIT 40660 i: Informasi Pengguna (44 halaman), Petunjuk Pengguna (40 halaman), Petunjuk Pengguna (44 halaman), Petunjuk Pengguna (48 halaman)

AEG OKO FAVORIT 40660 i Petunjuk Pengguna
Installation and Connection Instructions
The following section is only applicable to dishwashers that have a
3
safety valve on the threaded hose fitting for the tap:

Water inlet hose with safety valve

After connecting the double-walled water inlet hose, the safety valve is
next to the tap. Therefore the water inlet hose is only under pressure
while the water is running. If the water inlet hose starts to leak during
this operation, the safety valve cuts off the running water and the
draining pump in the dishwasher is switched on.
Please take care when installing the water inlet hose:
1
– The distance between the bottom
edge of the safety value and the
floor on which the dishwasher is
standing must be at least 30 cm:
– The electrical cable for the safety
valve is in the double-walled water
inlet hose. Do not immerse the
water inlet hose or the safety valve
in water.
– If the water inlet hose or the safety
valve is damaged, remove the
mains plug immediately.
– A water inlet hose with safety valve
must only be replaced by your local
Service Force Centre.
– Place the water inlet hose in such a way that it is never higher than
the bottom edge of the safety valve.
38