AEG OKO FAVORIT 40660 i Petunjuk Pengguna - Halaman 34
Jelajahi secara online atau unduh pdf Petunjuk Pengguna untuk Mesin pencuci piring AEG OKO FAVORIT 40660 i. AEG OKO FAVORIT 40660 i 44 halaman. Aeg dishwasher
Juga untuk AEG OKO FAVORIT 40660 i: Informasi Pengguna (44 halaman), Petunjuk Pengguna (40 halaman), Petunjuk Pengguna (44 halaman), Petunjuk Pengguna (48 halaman)
Halaman Cetak
Installation and Connection Instructions
Connecting the Dishwasher
Water Connection
The dishwasher is fitted with safety devices that prevent the wash
water returning into the drinking water system and comply with the
applicable plumbing regulations.
• The dishwasher must be connected to a cold water supply.
• The dishwasher must not be connected to open hot water appliances
or instantaneous water heaters.
Permitted water pressure
Lowest permitted water pressure:
1 bar (=10 N/cm
Highest permitted water pressure:
10 bar (=100 N/cm
Connect the inlet hose
The water inlet hose must not be kinked, crushed or entangled when it
1
is being connected up.
0
Connect the threaded hose fitting (ISO 228-1:2000) on the water inlet
hose to a tap with an external thread (¾ inch). Tighten the threaded
hose fitting hand tight only.
• In order that access to the tap in the kitchen is not limited by the use
3
of the dishwasher, we recommend the installation of an additional
tap, or fitting a two way adapter to the existing tap.
• If you need a longer water inlet hose than that supplied, VDE
approved complete hose sets are to be used. These are available from
your local Service Force Centre.
• Do not use, for connection, old hoses which have been used for
another appliance.
34
2
=100 kPa)
2
=1 MPa)
Consult your installer if the water pres-
sure is less than 1 bar.
In the case of a water pressure greater
than 10 bar, a pressure reduction valve
must be used (available from your
dealer).