AEG 21602 G Panduan Pengoperasian dan Instalasi - Halaman 25

Jelajahi secara online atau unduh pdf Panduan Pengoperasian dan Instalasi untuk Kompor AEG 21602 G. AEG 21602 G 26 halaman. Gas hob
Juga untuk AEG 21602 G: Petunjuk Pengoperasian dan Pemasangan (27 halaman)

Halaman Cetak

Commissioning

When the hob has been fully installed it will be necessary to check the

minimum flame setting. To do this, follow the procedure below.

1) Turn the gas tap to the MAX position and ignite.

2) Set the gas tap to the MIN flame position then turn the control

knob from MIN to MAX several times. If the flame is unstable or is

extinguished follow the procedure below.

Procedure:

1) Re-ignite the burner and set

to MIN.

2) Remove the control knob.

3) You can find two different

adjustment screw locations

according to the gas tap (see

diagram). The "b" type has

the adjustment screw

located down the centre of

th egas tap control shaft. The

"c" type has the by pass

screw located to the side of

the gas tap itself.

To adjust, use a thin bladed screwdriver and turn the adjustment

screw until the flame is steady and does not extinguish, when the

knob is turned from MIN to MAX. Repeat this procedure for all

burners.

Pressure Testing

1) Remove left hand pan support and front left burner cap and crown.

2) Fit manometer tube over the injector.

3) Turn on the burner gas supply and ignite another burner supply.

The pressure reading should be nominally 20mbar and must be

between 17 mbar and 25mbar.

4) Turn off the burner supplies.

FO 1032

a) Minimum adjustment screw

b) Tap