AEG 34611C Panduan Petunjuk Pengoperasian - Halaman 21

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kompor AEG 34611C. AEG 34611C 28 halaman. Gas hob
Juga untuk AEG 34611C: Panduan Pengoperasian dan Instalasi (24 halaman), Petunjuk Pengoperasian dan Pemasangan (24 halaman)

Permanent Connection

In the case of a permanent connection, it is necessary that you install a double pole

switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm.

between the switch contacts and of a type suitable for the required load in compliance with

the current electric regulations.

The switch must not break the yellow and green earth cable at any point.

Ensure that the hob supply cord does not come into contact with surfaces with temperatures

higher than 50 deg. C.

Replacement of the cable

The connection of the voltage cable to the appliance's terminal block is of type "Y". This

means that its replacement requires the specific equipment of a technician.

In this case, only cable types H05RR-F, H05 V2V2-F (T90) or H05 BB-F must be used.

The cable section must be suitable to the voltage and the working temperature.

The yellow/green earth wire must be approximately 2 cm. longer than the phase wires.

Wiring diagram

1. TAPS IGNITOR SWITCHES

2. IGNITOR UNIT

220

240