AEG 35601G Panduan Petunjuk Pengoperasian - Halaman 21

Jelajahi secara online atau unduh pdf Panduan Petunjuk Pengoperasian untuk Kompor AEG 35601G. AEG 35601G 28 halaman. Gas hob
Juga untuk AEG 35601G: Panduan Pengoperasian dan Instalasi (24 halaman), Petunjuk Pengoperasian dan Pemasangan (24 halaman)

AEG 35601G Panduan Petunjuk Pengoperasian
Permanent Connection
In the case of a permanent connection, it is necessary that you install a double pole
switch between the hob and the electricity supply (mains), with a minimum gap of 3 mm.
between the switch contacts and of a type suitable for the required load in compliance with
the current electric regulations.
The switch must not break the yellow and green earth cable at any point.
Ensure that the hob supply cord does not come into contact with surfaces with temperatures
higher than 50 deg. C.
Replacement of the cable
The connection of the voltage cable to the appliance's terminal block is of type "Y". This
means that its replacement requires the specific equipment of a technician.
In this case, only cable types H05RR-F, H05 V2V2-F (T90) or H05 BB-F must be used.
The cable section must be suitable to the voltage and the working temperature.
The yellow/green earth wire must be approximately 2 cm. longer than the phase wires.

Wiring diagram

N
1
L
1. TAPS IGNITOR SWITCHES
2. IGNITOR UNIT
1
220
240
2
3
0
4
2
21