AEG 35940G Petunjuk Pengoperasian dan Pemasangan - Halaman 21

Jelajahi secara online atau unduh pdf Petunjuk Pengoperasian dan Pemasangan untuk Kompor AEG 35940G. AEG 35940G 26 halaman. Gas hobs
Juga untuk AEG 35940G: Panduan Pengoperasian dan Instalasi (26 halaman), Petunjuk Pengoperasian dan Pemasangan (26 halaman), Petunjuk Pengoperasian dan Pemasangan (26 halaman), Petunjuk Pengoperasian dan Pemasangan (27 halaman)

Permanent Connection

In the case of a permanent connection, it is necessary that you install

a double pole switch between the hob and the electricity supply

(mains), with a minimum gap of 3 mm. between the switch contacts

and of a type suitable for the required load in compliance with the

current electric regulations.

The switch must not break the yellow and green earth cable at any

point.

Ensure that the hob supply cord does not come into contact with

surfaces with temperatures higher than 50 deg. C.

Replacement of the cable

The connection of the voltage cable to the appliance's terminal block

is of type "Y". This means that its replacement requires the specific

equipment of a technician.

In this case, only cable type H05RR-F must be used. The cable section

must be suitable to the voltage and the working temperature.

The yellow/green earth wire must be approximately 2 cm. longer than

the phase wires.

1. TAPS IGNITOR SWITCHES

2. IGNITOR UNIT

220

240