AEG 6410KF-N Panduan Petunjuk Pemasangan dan Pengoperasian - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Petunjuk Pemasangan dan Pengoperasian untuk Kompor AEG 6410KF-N. AEG 6410KF-N 28 halaman.
Halaman Cetak
What to do if ...
Problem
The cooking zones are not
functioning.
The cooking zones cannot
be selected / Appliance
does not react to the con-
trol panel input
The residual heat indicator
is not displaying anything
Er03
is displayed
Er21
is displayed
Er25
is displayed
(only for 10 seconds)
Er40
is displayed
3
In the event of any other fault codes that arise, disconnect the appli-
ance from the electrical supply for a few seconds (Take out the fuse
from the house's wiring system). If the fault code is displayed again,
please call your local Service Force Centre and report the fault code.
If you are unable to remedy the problem by following the above
suggestions, please contact your local Service Force Centre.
Possible cause
No cooking zone selected
More than 10 seconds has
passed since the appliance
was switched on
The child safety device is
l
activated
The sensor fields are partly
covered by a damp cloth or
with liquid
Safety cut-out has been
triggered
The cooking zone was only
on for a short time and is
therefore not hot
Several sensor fields were
touched at the same time
Safety cut-out due to
overheating.
Appliance is incorrectly
connected
The overvoltage protector
has been activated (for an
incorrect connection see
Er25
above
or for over-
heating of the electronic
Er21
components see
Remedy
Select cooking zone within
10 seconds of switching on
(Decimal point lights up)
Switch on the appliance
again.
Select cooking zone within
10 seconds of switching on
Deactivate the child safety
device (See section "Child
safety device")
Remove the cloth or the
liquid
Switch on the appliance
again
If the cooking zone is sup-
posed to be hot, call your
local Service Force Centre.
Only touch one sensor field
Let the appliance cool
down.
Remove cookware.
Disconnect the appliance
from the electrical supply
and have it connected
properly
Separate the appliance
from the mains for a few
minutes (remove the mains
fuse).
Let the appliance cool
)
down.
15