Brother HL 2030 Panduan Pengaturan Cepat - Halaman 4
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Printer Brother HL 2030. Brother HL 2030 18 halaman. Quick setup guide - english
Juga untuk Brother HL 2030: Panduan Pengaturan Cepat (30 halaman), Panduan Pengaturan Cepat (30 halaman), Panduan Servis (12 halaman)
Halaman Cetak
Regulations
Important
A shielded interface cable should be used in order to ensure compliance with
the limits for a Class B digital device.
Changes or modifications not expressly approved by Brother Industries, Ltd.
could void the user's authority to operate the equipment.
Radio interference (220-240 volt model only)
This printer follows EN55022 (CISPR Publication 22)/Class B.
Before you use this product, make sure that you use the following interface
cables.
1. A shielded parallel interface cable with twisted-pair conductors and that it
is marked "IEEE 1284 compliant".
2. A USB cable.
The cable must not be more than 2 meters long.
International E
S
NERGY
The purpose of the International
the development and popularization of energy-efficient office equipments.
®
E
S
As an
NERGY
TAR
Partner, Brother Industries, Ltd. has determined
that this product meets the
efficiency.
IEC 60825-1 specification (220 to 240 volt model only)
This printer is a Class 1 laser product as defined in IEC 60825-1
specifications. The label shown below is attached in countries where it is
needed.
CLASS 1 LASER PRODUCT
APPAREIL À LASER DE CLASSE 1
LASER KLASSE 1 PRODUKT
This printer has a Class 3B laser diode which produces invisible laser
radiation in the scanner unit. You should not open the scanner unit under any
circumstances.
☛ Caution:
Use of controls or adjustments or performance of
procedures other than those specified herein may result in
hazardous radiation exposure.
Internal laser radiation
Maximum radiation power: 5 mW
Wave length:
Laser class:
IMPORTANT - For Your Safety
To ensure safe operation the supplied three-pin plug must be inserted only
into a standard three-pin power outlet that is properly grounded through the
normal household wiring.
Extension cords used with this printer must be three-pin plug type and
correctly wired to provide proper grounding. Incorrectly wired extension
cords may cause personal injury and equipment damage.
The fact that the equipment operates satisfactorily does not imply that the
power is grounded and that the installation is completely safe. For your
safety, if in any doubt about the effective grounding of the power, call a
qualified electrician.
Disconnect device
You must install this printer near a power outlet that is easily accessible. In
case of an emergency, you must disconnect the power cord from the power
outlet to shut off the power completely.
Caution for LAN connection (For model HL-2070N only)
Connect this product to a LAN connection that is not subjected to over
voltages.
4
®
Compliance Statement
TAR
E
S
®
NERGY
TAR
Program is to promote
®
E
S
NERGY
TAR
guidelines for energy
770 - 810 nm
Class 3B