AEG 914 550 925 Panduan Pengguna - Halaman 15
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG 914 550 925. AEG 914 550 925 48 halaman.
Halaman Cetak
7. BEFORE FIRST USE
During installation or before
first use you may observe
some water in the appliance.
This is a residual water left
in the appliance after a full
functional test in the factory
to ensure the appliance is
delivered to customers in
perfect working order and is
no cause for concern.
1. Make sure that all transit bolts have
been removed from the appliance.
2. Make sure that the electrical power is
available and the water tap is open.
3. Make sure that there is salt in the
compartment marked by
8. THE WATER SOFTENER (SOFTWATER
TECHNOLOGY)
8.1 Introduction
The water contains harsh minerals. The
higher the content of these minerals the
harder the water is.
Hard water can reduce the effectiveness
of the detergent, reduce the softness of
fabrics and contribute towards shrinkage
and colour fading.
This appliance is equipped with a water
softener able to provide the right degree
of water softening to preserve the fabric
integrity, colour brightness and ensuring
good wash performances at low
temperature.
The water softener should be adjusted
according to the water hardness of your
inlet water. A correct setting allows to
achieve the best washing results and the
maximum garments protection.
To set the water softener correctly,
please refer to 'How to set the water
hardness level'.
4. Pour 2 litres of water into the
This action activates the drain system.
5. Pour a small quantity of detergent
6. Set and start a programme for cotton
This removes all possible dirt from the
drum and the tub.
Salt
and set
8.2 How to set the water
hardness level
The appliance allows you to chose
between 7 levels corresponding to 7
different ranges of water hardness.
Depending on the country, the water
hardness is expressed in equivalent
scales: e.g. French degrees (°f), German
degrees (°d), English degrees (°e),
mmol/l and ppm.
If necessary, please contact your local
water authority to check the water
hardness in your area.
Check in the "Water hardness levels"
table which is the proper level.
To set the water hardness level:
1. Press the On/Off button for a few
2. Wait about 10 seconds for appliance
3. Touch the Stains/Prewash and the
the proper water hardness level.
Refer to "How to set the water
hardness level".
detergent compartment marked by
.
into the compartment marked by
at the highest temperature without
any laundry in the drum.
seconds to activate the appliance.
internal check.
Plus Steam buttons simultaneously
(by touching the two buttons at the
same instant, as shown in the next
drawing) for some seconds until the
display shows the default level C04
and the indicator
ENGLISH
15
.
goes on. It