Fujitsu Lifebook C2240 Manual Perangkat Lunak - Halaman 11
Jelajahi secara online atau unduh pdf Manual Perangkat Lunak untuk Laptop Fujitsu Lifebook C2240. Fujitsu Lifebook C2240 39 halaman. Bios setup utility
Halaman Cetak
Serial/Parallel Port Configuration Submenu of the Advanced Menu
The Serial/Parallel Port Configuration submenu
provides the ability to set the I/O addresses and
interrupt levels for the serial, infrared and parallel
ports of your notebook.
C A U T I O N
I/O addresses, DMA channels and Interrupt levels
can be entered in various ways, including via the BIOS
setup utility, the control software for the I/O device,
or the hardware. If any two ports or devices, serial or
parallel, have the same I/O address assigned your
notebook will not function normally. Please keep a
record of original settings before making any changes
in the event that a restoration is required. See your
hardware and software documentation as well as the
setup utility to determine settings, limitations, etc.
Serial Port:
I/O Address:
Interrupt:
Infrared Port:
Mode:
I/O Address:
Interrupt:
I/O Address:
DMA Channel:
Parallel Port:
Mode:
I/O Address:
Interrupt:
F1
Help
ESC
Exit
PhoenixBIOS Setup Utility
Advanced
Serial/Parallel Port Configurations
Select Item
-/Space
Select Menu
Figure 5 Serial/Parallel Port Configuration Submenu
P O I N T
To prevent IRQ and address conflicts, avoid changing
the default settings. If you must change the settings,
you can call 1-800-8FUJITSU for technical assistance.
C A U T I O N
The BIOS will warn you of a resource conflict by placing
a yellow asterisk next to each device that is in conflict.
P O I N T
All I/O addresses in Table 5 are in hexadecimal.
[Enabled]
[3F8-3FF]
[IRQ 4]
[Enabled]
[FIR]
[2E8 - 2EF]
[IRQ 3]
[118-11F]
[DMA 3]
[Enabled]
[Bi-directional]
[378-37F]
[IRQ 7]
Change Values
Enter
Select
Sub-Menu
A d v a n c e d M e n u
Item Specific Help
[Disabled]
The port is disabled.
[Enabled]
the port is enabled
with user configuration.
[Auto]
the port is configured
depending on 'Plug &
Play OS' setting.
F9
Setup Defaults
F10
Save and Exit
11