Brother P-TOUCH CUBE Panduan Pengguna - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuat label Brother P-TOUCH CUBE. Brother P-TOUCH CUBE 18 halaman. Tze tape
Juga untuk Brother P-TOUCH CUBE: Panduan Pengguna (25 halaman), Panduan Pengguna (18 halaman), Panduan Pengguna (18 halaman), Panduan Pengguna (18 halaman)

Halaman Cetak

3. Inserting the Tape Cassette

Make sure your Tape Cassettes display the TZe mark (

Use only tape widths of 3.5 mm, 6 mm, 9 mm, or 12 mm.

If there is a stopper on the TZe Tape Cassette, remove it before installation.

1. Hold the label printer as shown in the

illustration. Open the Cassette Cover

by pressing the mark on its side (1) and

pulling in the direction of the arrow (2).

2. Insert the Tape Cassette following the

drawing marked inside the case.

Confirm that the tape is aimed at the

green Tape Outlet and gently press the

Tape Cassette into the label printer

until it locks into place.

NOTE

• Make sure that there is no slack in the

tape. To fix any slack, pull the end of

the tape out of the Tape Guide.

• When inserting or removing the Tape

Cassette, make sure that the tape

does not catch on the silver pin (3) or

the Print Head.

3. Insert the two hooks at the rear of the

Cassette Cover into the slots on the

label printer (4). Push the Cassette

Cover closed (5), making sure it locks

into place.

End of Tape

Tape Guide

Cassette Cover

Print Head