Brother P-touch E550WVP Panduan Pengaturan Cepat - Halaman 36

Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pembuat label Brother P-touch E550WVP. Brother P-touch E550WVP 47 halaman.

EDITING A LABEL

PUNCH-DOWN BLOCK

Labels printed with this mode can be used to identify a type of electrical connection often
used in telephony. There are up to three lines for each block on a single label and you can
enter three lines for each block. In this mode, you can specify the following items.
• Module Width: 200 mm, 50 mm - 300 mm
• Block Type: 4 Pairs, 2 Pairs, 3 Pairs, 5 Pairs, Blank
• Sequence Type:
• Start Value: ---, 1 - 99999
• When "Blank" is selected in "Block Type", "Sequence Type" is set to None.
• When None is selected in "Sequence Type", "Start Value" shows "---" and you cannot set
a value. Selecting Horizontal or Backbone however, allows you to set the "Start Value"
from 1 to 99999.

Heat Shrink Tube

When using Heat Shrink Tube, the HEAT-SHRINK TUBE setting screen
will be displayed when any of the labeling application type keys is
pressed.
• Label length: Auto, 10 mm - 999 mm
However, the maximum printing length is 500 mm when using Heat Shrink Tube with a
width of 5.8 mm or 8.8 mm.
Text: Type in single or multiple lines of data
When using Heat Shrink Tube:
• You cannot print frames.
• Portions of some decorative characters may be cut off when a line is broken.
• The printed characters may be smaller than when using TZe tape.
36
Selecting a Labeling Application Type
(None),
(Horizontal),
(Backbone)