Brother P-touch E800T Panduan Pengaturan Cepat - Halaman 3
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pembuat label Brother P-touch E800T. Brother P-touch E800T 8 halaman.
Halaman Cetak
Inserting a Tube
1.
Open the top cover.
2.
Pull the tube release lever up.
3.
Pass the tube as shown in the illustration so that the end of the tube
reaches the "
" mark on the P-touch, and then push the tube
release lever down.
4.
Close the top cover.
NOTE
•
Do not use tube which is dirty, bent, flattened, has a rough surface or
uneven tube thickness, or is defective in any other way.
•
When using the P-touch, position it so direct sunlight does not enter
the P-touch through the tube exit slot.
•
You can use the tube half-cut adjuster to adjust the depth of half cuts
to one of three settings.
•
If the tube is jammed or not cut completely, use the
Cut) button to manually cut the tube completely. Press and hold the
button for 2 to 10 seconds until the
being lit in green to flashing in green, and then release it. The tube
will be cut when the button is released.
Inserting a Ribbon Cassette
1.
Open the top cover.
2.
Insert the ribbon cassette into the ribbon cassette compartment, and
press it firmly until you hear a click.
3.
Close the top cover.
(Feed and
(Power) indicator changes from
Inserting a Tape Cassette
The TZe tape, FLe label, and HSe tube cassettes can be used in your
P-touch.
IMPORTANT
If the new tape cassette has a cardboard stopper,
be sure to remove the stopper before inserting the
cassette.
1.
Check that the end of the tape is not bent and that it passes through the
tape guide. If it does not, pass it through the tape guide as shown in the
illustration.
1
2
1
End of tape
2
Tape guides (The actual shape may be different depending on
the tape width.)
2.
Open the top cover.
3.
Insert the tape cassette into the tape cassette compartment with the end
of the tape facing the P-touch tape exit slot, then push down evenly until
the tape cassette is installed correctly.
1
IMPORTANT
•
When inserting the tape cassette, make sure that the tape and ink
ribbon do not catch on the print head.
•
Make sure that there is no slack in
the tape, and then carefully insert
the tape cassette. If there is slack
in the tape, the tape will catch on
the protrusion (2) when the
cassette is inserted and become
bent or wrinkled, causing the tape
to jam.
To fix the slack in the tape, refer to
the illustration in step 1 and pull the tape outside of the tape guide.
•
When removing the tape cassette, make sure that the tape does not
catch on the protrusion (2).
4.
Close the top cover.
IMPORTANT
Store tape cassettes in a cool dark location, away from direct sunlight
and high temperature, high humidity, or dusty locations. After opening
the sealed package, use the tape cassette as quickly as possible.
1
2
1
Tape exit slot
2