Brother P-Touch QL-500 Panduan Pengguna - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pembuat label Brother P-Touch QL-500. Brother P-Touch QL-500 19 halaman. Quick setup guide - spanish
Juga untuk Brother P-Touch QL-500: Panduan Memulai Cepat (2 halaman), Brosur (6 halaman), Panduan Memulai Cepat (2 halaman), Panduan Memulai Cepat (2 halaman), Panduan Instalasi Perangkat Lunak (15 halaman), Panduan Memulai Cepat (2 halaman), (Bahasa Inggris) Panduan Cepat (2 halaman)

LED Lamp

The LED lamp on the QL-500/560 indicates the current operating condition.

Lamp

Not lit

Lit

Flashing fast

Flashing slow

Turns off after flashing

fast ten times

Press the ON/OFF button to turn the QL-500/

560 off. Hold the DK Roll compartment cover at

the sides near the front of the QL-500/560 and

firmly lift up to open the cover.

Place the spool into the spool guides in the DK

Roll compartment.

Make sure that the spool arms are inserted firmly in

•

the spool guides on the left and right.

Insert the spool with the DK Roll located on the right

•

hand side of the QL-500/560.

Power is OFF.

Power is ON.

(Normally lit while power is on, the LED flashes during cleaning or if an

error has occurred.)

Indicates one of the following errors.

• Cutter error

• Label sensor error

(DK Roll not installed correctly, end of DK Roll, or label jam)

• DK Roll compartment cover is open during operation

• Incorrect DK Roll installed

• No DK Roll installed

Cooling

(Waiting for temperature of print head to lower)

System error

Turn the QL-500/560 off and then on again.

If this error re-occurs, contact the retail outlet where the QL-500/560 was

purchased or your local authorized service centre.

Condition

STEP