AEG L 79484 EFL Panduan Pengguna - Halaman 24
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG L 79484 EFL. AEG L 79484 EFL 28 halaman.
Halaman Cetak
24
www.aeg.com
Problem
You cannot open the ap-
pliance door.
The appliance makes an
unusual noise.
The cycle is shorter than
the time displayed.
The cycle is longer than
the time displayed.
The washing results are
not satisfactory.
You cannot set an op-
tion.
After the check, activate the appliance. The programme continues from the point of
interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the
problem continues, contact the Authorised Service Centre.
14. EMERGENCY DOOR OPENING
In case of power failure or appliance
failure the appliance door remains
locked. The washing programme
continues, when the power is restored. If
the door remains locked in case of
failure, it is possible to open it using the
emergency unlock feature.
Possible solution
Make sure that the washing programme is finished.
Set the drain or the spin programme if there is water in the
drum.
Make sure that the appliance receives electrical power.
This problem may be caused by a failure of the appliance.
Contact the Authorised Service Centre. If you need to open
the door, please read carefully «Emergency door opening».
Make sure the levelling of the appliance is correct. Refer to 'In-
stallation'.
Make sure that the packaging and/or the transit bolts are re-
moved. Refer to 'Installation'.
Add more laundry in the drum. The load may be too small.
The appliance calculates a new time according to the laundry
load. See the 'Consumption Values' chapter.
An unbalanced laundry load increases the duration time. This
is a normal behaviour of the appliance.
Increase the detergent quantity or use a different detergent.
Use special products to remove the stubborn stains before you
wash the laundry.
Make sure that you set the correct temperature.
Decrease the laundry load.
Make sure that you press only the wanted button(s).
Before opening the door: