AEG L 87405 FL Panduan Pengguna - Halaman 26

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG L 87405 FL. AEG L 87405 FL 32 halaman. Clothes washer
Juga untuk AEG L 87405 FL: Panduan Pengguna (28 halaman)

Halaman Cetak

www.aeg.com

Switch off and switch on again. The

programme was not finished properly

or the appliance stopped too early. If

the alarm code appears again,

contact the Authorised Service

Centre.

•

- The anti-flood device is on.

Disconnect the appliance and close

13.2 Possible failures

Problem

The programme does

not start.

The appliance does not

fill with water properly.

The appliance does not

fill with water and drain

immediately.

The appliance does not

drain the water.

Possible solution

• Make sure that the mains plug is connected to the mains

socket.

• Make sure that the appliance door is closed.

• Make sure that there is not a damaged fuse in the fuse box.

• Make sure that the Start/Pause has been pressed.

• If the delay start is set, cancel the setting or wait for the end

of countdown.

• Deactivate the Child Lock function if it is on.

• Make sure that the water tap is open.

• Make sure that the pressure of the water supply is not too

low. For this information, contact your local water authority.

• Make sure that the water tap is not clogged.

• Make sure that the filter of the inlet hose and the filter of

the valve are not clogged. Refer to "Care and cleaning".

• Make sure that the inlet hose has no kinks or bends.

• Make sure that the connection of the water inlet hose is

correct.

• Make sure that the connections of the water inlet hoses are

correct.

• Make sure that the drain hose is in the correct position. The

hose may be too low. Refer to 'Installation instruction'.

• Make sure that the sink spigot is not clogged.

• Make sure that the drain hose has no kinks or bends.

• Make sure that the connection of the drain hose is correct.

• Set the drain option if you set a programme without drain

phase.

• Set the drain option if you set an option which ends with

water in the drum.

• Make sure that the drain filter is not clogged. Clean the fil-

ter, if necessary. Refer to 'Care and cleaning'.

• If problem remains please contact the Authorised Service

Centre.

the water tap. Contact the Authorised

Service Centre.

WARNING!

Deactivate the appliance

before you do the checks.