AEG L 87406 FL Panduan Pengguna - Halaman 26
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG L 87406 FL. AEG L 87406 FL 28 halaman. Clothes washer
Halaman Cetak26 www.aeg.com
Problem
The cycle is short-
er than the time
displayed.
The cycle is longer
than the time dis-
played.
The washing re-
sults are not satis-
factory.
After the check, activate the appliance.
The programme continues from the
point of interruption.
If the problem occurs again, contact the
service centre.
12. TECHNICAL INFORMATION
Dimensions
Electrical connection:
Level of protection against ingress of solid particles
and moisture ensured by the protective cover, ex-
cept where the low voltage equipment has no pro-
tection against moisture
Water supply pressure
Water supply
Maximum load
Spin speed
1) Connect the water inlet hose to a water tap with a 3/4'' thread.
Possible cause
The load is very small.
The appliance calculates
a new time according to
the laundry load.
An unbalanced laundry
load increases the dura-
tion time.
The detergent you used
was not sufficient or cor-
rect.
You did not remove the
stubborn stains before
you wash the laundry.
Incorrect temperature
was set.
Too much laundry load.
Width / Height / Depth
Total depth
Voltage
Overall power
Fuse
Frequency
Minimum
Maximum
1)
Cotton
Maximum
Possible solution
Add more laundry in the drum.
See the 'Consumption Values'
chapter.
This is a normal behaviour of
the appliance.
Increase the detergent quantity
or use a different one.
Use special products to remove
the stubborn stains.
Make sure that you set the cor-
rect temperature.
Decrease the laundry load.
If the display shows other alarm codes,
contact the service centre.
600 / 850 / 605 mm
640 mm
230 V
2200 W
10 A
50 Hz
IPX4
0,5 bar (0,05 MPa)
8 bar (0,8 MPa)
Cold water
10 kg
1400 rpm