Brother PT-E500 Panduan Pengaturan Cepat - Halaman 24
Jelajahi secara online atau unduh pdf Panduan Pengaturan Cepat untuk Pembuat label Brother PT-E500. Brother PT-E500 46 halaman. Electronic labeling system
Juga untuk Brother PT-E500: Panduan Operator (6 halaman)
Halaman Cetak
GETTING STARTED
3
Confirm that the hooks on the edge of the rear cover are inserted correctly, and then
reattach the cover.
If you cannot attach the rear cover, check to ensure the white lever is in the up position. If not, lift
the lever, and then attach the cover.
Removing the Rechargeable Li-ion Battery
Remove the battery cover and the rechargeable Li-ion battery, and then reattach the battery
cover.
Charging the Rechargeable Li-ion Battery
The rechargeable Li-ion battery can be charged while it is inserted in the P-touch labeling
system. Perform the following procedure to charge the rechargeable Li-ion battery.
• Before using the rechargeable Li-ion battery, use the following procedure to charge it.
• Up to 6 hours may be needed to fully charge the rechargeable Li-ion battery.
1
Make sure that the P-touch labeling system is turned off. If the P-touch labeling system
is turned on, press the
2
Make sure that the rechargeable Li-ion battery is installed in the P-touch labeling
system.
3
Use the AC adapter to connect the P-touch labeling system to
an AC power outlet.
The LED next to the adapter connector turns on during
charging, it goes off when the rechargeable Li-ion battery is
fully charged. The battery level indicator on the display will fill
three bars
Stopping Rechargeable Li-ion Battery Charging
To stop the rechargeable Li-ion battery from charging, disconnect the AC adapter.
Tips on Using the Rechargeable Li-ion Battery
• Charge the rechargeable Li-ion battery before use. Do not use it before it is charged.
• The rechargeable Li-ion battery charging can take place in 5°C to 35°C environments. Charge
the rechargeable Li-ion battery in an environment in this temperature range. If the surrounding
temperature is out of this range, the rechargeable Li-ion battery will not be charged, and the
battery indicator will remain lit.
• If the P-touch labeling system is used when both the rechargeable Li-ion battery is installed and
the AC adapter is connected, the battery indicator may turn off and charging may stop even if
the rechargeable Li-ion battery has not been fully charged.
24
Power Supply
(Power) button to turn it off.
.