AEG L61470WDBI Panduan Pengguna - Halaman 34
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG L61470WDBI. AEG L61470WDBI 36 halaman.
Juga untuk AEG L61470WDBI: Panduan Pengguna (40 halaman)
Halaman Cetak
34
www.aeg.com
16-22 mm
Ø 35 mm
14 mm
416
mm
22±1,5 mm
595-598 mm
2
1
A
B
A
B
C
Door
The dimensions of the door should be:
• width 595 - 598 mm
• thickness 16-22 mm
X
• the height X depends on the height of the
adjacent furniture's base.
Hinges
To mount the hinges it is necessary to drill
two holes (dia. 35 mm, depth12.5-14 mm
depending on the depth of door furniture) on
the inner side of the door.
The distance between the hole fixing centres
must be 416 mm. The distance from upper
edge of the door to the centre of the hole
depends on the adjacent furniture's
dimensions.
The hinges will be fixed to the door by means
of screws for wood 1 and 2 supplied with the
appliance.
Mounting the door
WARNING!
Do not remove the screw B.
Fix the hinges to the appliance by means of
the M5x15 screws.
The hinges can be adjusted to compensate
for possible uneven thickness of the door.
To align the door perfectly it is necessary to
loosen the screw, adjust the door and tighten
the screw A again.
Counter-magnet
WARNING!
Do not remove the screw B.
The appliance is pre set for a magnetic door
closure. To position the closure correctly, it is
necessary to screw the counter-magnet A
(steel disk + rubber ring) into the inner side of
the door.
Its position must correspond to the magnet B
on the appliance.