AEG L6FBF60488 Panduan Pengguna - Halaman 33
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG L6FBF60488. AEG L6FBF60488 40 halaman.
Halaman Cetak
20°
14.11 Emergency drain
If the appliance cannot drain the water,
carry out the same procedure, described
in 'Cleaning the drain pump' paragraph. If
necessary, clean the pump.
14.12 Frost precautions
If the appliance is installed in an area
where the temperature can reach the
15. TROUBLESHOOTING
WARNING!
Refer to Safety chapters.
15.1 Alarm Codes and Possible failures
The appliance does not start or it stops during operation. First try to find a solution to the
problem (refer to the tables).
WARNING!
Deactivate the appliance before carrying out any check.
With some problems, the display shows an alarm code and the
Start/Pause button may flash continuously:
Problem
The appliance does
not fill with water prop‐
erly.
45°
Possible solution
•
Make sure that the water tap is open.
•
Make sure that the pressure of the water supply is not too low.
For this information, contact your local water authority.
•
Make sure that the water tap is not clogged.
•
Make sure that the inlet hose has no kinks, damages or
bends.
•
Make sure that the connection of the water inlet hose is cor‐
rect.
•
Make sure that the filter of the inlet hose and the filter of the
valve are not clogged. Refer to 'Care and cleaning'.
values around 0° C or drop below,
remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in
a container and let the water flow out
of the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty,
install the inlet hose again.
WARNING!
Make sure that the
temperature is higher than
0 °C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.
ENGLISH
33