AEG L6FBN8400 Panduan Pengguna - Halaman 23
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG L6FBN8400. AEG L6FBN8400 40 halaman.
Halaman Cetak
12.6 Starting a programme
with the delay start
Touch the Start/Pauze button.
The appliance starts the countdown of
the delay start.
When the countdown is completed, the
programme starts.
The PROSENSE adapts
starts at the end of the
countdown.
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Start/Pauze button to
pause the appliance. The related
indicator flashes.
2. Touch the Startuitstel button
repeatedly until the display shows
3. Touch the Start/Pauze button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Start/Pauze button to
pause the appliance. The related
indicator flashes.
2. Touch the Startuitstel button
repeatedly until the display shows the
desired delay time.
3. Touch the Start/Pauze button again
to start the new countdown.
12.7 Starting a programme
Touch the Start/Pauze button to start the
programme.
The related indicator stops flashing and
stays on.
The programme starts, the door is
locked. The display shows the indicator
.
The drain pump can operate
shortly before the appliance
fills water.
12.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
1. The appliance detects the load in the
first 30 seconds: the indicator
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
.
Once removed the exceeding garments,
touch the Start/Pauze button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as Wol/
Zijde, programmes with
short cycles and without
washing phase.
ENGLISH
goes off and the time
23
and