Fujitsu PRIMEPOWER 2500 Panduan Platform Perangkat Keras - Halaman 32
Jelajahi secara online atau unduh pdf Panduan Platform Perangkat Keras untuk Server Fujitsu PRIMEPOWER 2500. Fujitsu PRIMEPOWER 2500 50 halaman. Enterprise servers
Juga untuk Fujitsu PRIMEPOWER 2500: Manual (21 halaman)
Halaman Cetak
protocol.
Since PRIMECLUSTER GLS 4.1A20 or previous version do not correspond to a VLAN interface,
please do not use VLAN interface with those. PRIMECLUSTER GLS 4.1A30 or later (only Fast
switching mode or NIC switching mode) can use VLAN interface.
VLAN function can be used only in Solaris 8, Solaris 9 or Solaris 10.
In the environment where PRIMECLUSTER has been installed, in case you use a VLAN interface,
please check that the "SMAWdtcp" package has not been installed. When installed, please remove
that package or do not use a VLAN interface.
A VLAN interface uses about 700Kbyte at MTU size 1514byte or 900Kbyte at MTU size 9014byte of
memory (at the time of no communicating). Therefore, when creating two or more VLAN interfaces
and performing communication, a slowdown may occur due to the shortage of resources depending on
the system configuration.
4.4
Messages
Messages by fjgi driver are listed in the following table.
Table 4.3 Console Messages of the fjgi driver
Message
network connection down
network connection up
using portA
speed:
autonegotiation:
duplex mode:
flowctrl:
( role:
)*1
26
Cause
Link down was happened.
Connected
-speed
1000: Transmitting and receiving by
1000Mbps
100: Transmitting and receiving by
100Mbps
10: Transmitting and receiving by
10Mbps
-autonegotiation
on: Set in autonegotiation
off: Not setting in autonegotiation
-duplex mode
full: Transmitting and receiving by
full duplex
half: Transmitting and receiving by
half duplex
-flowctrl
symmetric: Doing Flowcontrol each
other
remote send: Accept Flowcontol only
from
the
local send: Doing only own
Flowcontrol
none: Not doing Flowcontrol.
Workaround
When Link down not intended is
generated, abnormality of the
transmission line is thought. Please
confirm the specification of the cable
and the switch.
There is no problem.
other.