AEG L7FEE842S Panduan Pengguna - Halaman 27
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Mesin cuci AEG L7FEE842S. AEG L7FEE842S 48 halaman.
Juga untuk AEG L7FEE842S: Panduan Pengguna (40 halaman)
Halaman Cetak
Cancelling the delay start
after the countdown has
started
To cancel the delay start:
1. Touch the Inicio/Pausa button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows
3. Touch the Inicio/Pausa button again
to start the programme immediately.
Changing the delay start after
the countdown has started
To change the delay start:
1. Touch the Inicio/Pausa button to
pause the appliance. The related
indicator flashes.
2. Touch the Inicio Diferido button
repeatedly until the display shows the
desired delay time.
3. Touch the Inicio/Pausa button again
to start the new countdown.
12.8 The ProSense load
detection
The programme duration in
the display is referred to a
medium/high load.
After touching the Inicio/Pausa button,
the maximum declared load indicator
goes off, the indicator
ProSense starts the laundry load
detection:
1. The appliance detects the load in the
first 30 seconds: the indicator
the time dots flash, the drum rotates
shortly.
2. At the end of the load detection, the
indicator
goes off and the time
dots stop flashing. The programme
duration will be adjusted accordingly
and could increase or decrease. After
further 30 seconds, the water filling
starts.
At the end of the load detection, in case
of drum overload, the indicator
flashing in the display:
In this case, for 30 seconds, it is possible
to pause the appliance and remove the
exceeding garments.
Once removed the exceeding garments,
touch the Inicio/Pausa button to start the
programme again. The ProSense phase
can be repeated up to three times (see
point 1).
Important! If the laundry amount will not
be reduced, the washing programme
.
starts anyway, despite the overload. In
this case, it will be not possible to
guarantee the best washing results.
12.9 Programme phase
flashes, the
indicators
When the programme starts the indicator
of the running phase flashes and the
other phase indicators are steady on.
and
E.g. the washing or pre wash phase is
running:
When the phase ends the relevant
indicator stops flashing and is steady on.
The next phase indicator starts flashing.
E.g. the rinse phase is running:
If you select the Vapor Plus the steam
phase indicators come on.
is
About 20 minutes after the
programme start, the
programme duration could
be adjusted again depending
on the capacity of water
absorption of the fabrics.
The ProSense detection is
carried out with complete
washing programmes only
(no skipping phase
selected).
The ProSense is not
available with some
programmes, such as
Lana/Lãs + Seda,
programmes with short
cycles and without washing
phase.
.
ENGLISH
27
.