2N EasyGate Pro Mulai Cepat - Halaman 2
Jelajahi secara online atau unduh pdf Mulai Cepat untuk Gerbang 2N EasyGate Pro. 2N EasyGate Pro 4 halaman. Umts gateway
Juga untuk 2N EasyGate Pro: Mulai Cepat (4 halaman), Mulai Cepat (2 halaman), Mulai Cepat (4 halaman)
Halaman Cetak
®
2N
EasyGate Pro Quick Start
• The primary purpose of 2N
(from now only 'Easy Gate') is to transmit
voice between a GSM network and an
attached FXO-interface terminal.
• You can establish data connections (GPRS,
CSD) and send/receive SMS in combination
with a PC.
• Models of EasyGate with fax converter can
transmit fax messages using analog fax
Group 3 or data using analog modem on
telephone line.
Read the User Manual carefully to get familiar with all system functions at
wiki.2n.com.
EasyGate supports GSM GPRS technology for data connection. The connection speed
and quality depend on the GSM provider, accessible services, signal coverage and
network status.
®
2N
• Proper Location
- Install EasyGate with respect to a good
GSM signal strength.
- Place EasyGate out of range of sensitive
devices
and
electromagnetic interference reasons.
- EasyGate is designed for indoor use. Do
not place it near heat sources and on
direct solar radiation. It may not be
exposed to rain, flowing water and
moisture, aggressive gas, solvents etc.
• External Antenna Connection
Screw the antenna cord into the SMA
antenna
connector.
antenna connector gently with your
hand, never use a wrench!
• SIM Card Installation
Slot for SIM card is placed on the
connector panel. Insert the SIM card to
the slot according to the picture and
make sure that the card is locked
properly.
Select
provider and SIM card services, such as
call forwarding, call barring, preferred
networks, SMS centre, etc. using your
mobile phone before inserting your SIM
Basic Functions
®
EasyGate Pro
EasyGate Pro Installation and Connection
human
bodies
Tighten
the
required
• You
can
programmed
sending input.
• The battery backed-up EasyGate version
allows you to maintain your traffic even in
the event of power outage.
• Firmware for EasyGate can be updated
from www.2n.com
card into EasyGate.
• Telephone Line Connection
EasyGate can be connected to any
FXO-interface
for
telephone set, answering machine, PBX
CO line...). EasyGate is equipped with
identification of calling party (CLIP) via
FSK and so it is advantageous to connect
a terminal that is able to display the CLI.
• Battery
backup type)
Insert
battery NiMh size AA into the covered
the
compartment on the back side of the
gateway. Refer to the compartment
label for proper battery placement and
polarity.
batteries only!
• Mains
Switch On
EasyGate is 12 V DC voltage powered.
GSM
Connect the attached power adapter
(12 V / 0,5 A DC) to the power supply
connector. Battery backup types are
equipped with the power switch.
send
an
SMS
number
using
equipment
installation
four
pieces
of
Use
mentioned
Supply
Connection
to
a
pre-
the
SMS
(standard
(battery
rechargeable
type
of
and