Fujitsu PRIMERGY RX200 S3 Panduan Suplemen Servis - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Suplemen Servis untuk Server Fujitsu PRIMERGY RX200 S3. Fujitsu PRIMERGY RX200 S3 49 halaman.
Juga untuk Fujitsu PRIMERGY RX200 S3: Mulai Manual (8 halaman)
Halaman Cetak
4
Replacing components
V
CAUTION!
When handling systems and boards, make sure you observe the safety
information in the chapter "Safety Instructions" on
4.1
Preparation
To replace components which are not hot-pluggable, proceed as follows:
Ê Exit all applications and shut down the server correctly.
Ê If your operating system has not switched off the server, press the On/Off
button.
Ê Unplug the power plugs.
4.2
Pulling out / removing the server
Figure 2: Removing the server
Ê Undo the knurled screws (1) and pull the server carefully out of the rack (2)
as far as it will go.
Ê If the pulled-out server is difficult to access in the rack, remove it completely
from the rack. If you do not want to remove the server, skip this page.
RX200 S3
Service Supplement
page
11ff.
2
T
COM PAC
COM PAC
T
1
1
17