Fujitsu PRIMERGY RX200 S3 Panduan Suplemen Servis - Halaman 28
Jelajahi secara online atau unduh pdf Panduan Suplemen Servis untuk Server Fujitsu PRIMERGY RX200 S3. Fujitsu PRIMERGY RX200 S3 49 halaman.
Juga untuk Fujitsu PRIMERGY RX200 S3: Mulai Manual (8 halaman)
Halaman Cetak
Replacing the system board
Installing the system board
Ê Insert the system board at a slight angle and push the connectors into the
external connection panel. You will have to overcome a slight spring
resistance.
Ê Carefully lower the system board into the housing.
If necessary, adjust the position of the system board by turning it slightly.
Ê Fasten the system board with the nine screws (see figure on
Ê Reconnect all cables.
I
For cabling information see
Ê Reinstall the riser card holder.
Ê Reinstall the processor(s).
Ê Reinstall the memory modules in their slots.
I
To ensure correct operation, make sure you do the following after
installing the new system board:
– Update the BMC firmware and the BIOS
– Set the BIOS default values
– Set the customer-specific settings
This completes the replacement of the system board.
1
The relevant procedure is described in the Options Guide.
28
page
36.
1
1
Service Supplement
Replacing components
page
1
27).
RX200 S3