Fujitsu Primergy RX600 Mulai Manual - Halaman 6

Jelajahi secara online atau unduh pdf Mulai Manual untuk Server Fujitsu Primergy RX600. Fujitsu Primergy RX600 8 halaman.

Halaman Cetak

Turning off the power and installing optional devices

Install optional devices after OS installation.

"Chapter 6 Installing Internal Options"

Check that no medium is inserted in

the floppy disk drive nor the CD/DVD

drive.

Exit the OS.

After the OS is exited, the server will be automati-

cally turned off. When the server is not turned off

after the OS is exited, press the power switch on the

front of the server.

Turn off the power supply of the periph-

eral devices such as a display.

Install optional devices.

Hints for error handling

In preparation for a failure, set the following:

"Chapter 4 Operations after OS Installation

- Set to collect memory dump

By setting to collect memory dump, debugging information

is automatically saved when a STOP error (blue screen) or a

hangup occurs in the system. It helps to analyze the cause of

errors.

- Create backup data for system recovery

After OS installation is complete, create backup data for

system recovery. It enables the system to recover when any

trouble occurs.

For Windows Server 2008, back up whole server configura-

tion to a shared folder on another server or a medium such

as a DVD.

For Windows Server 2003, create the Automated System

Recovery (ASR) set.

- Store system settings

By storing the BIOS setting information, the original infor-

mation can be recovered with the stored information in case

that the setting information is lost. The stored information

is also used for the system maintenance.

When the settings are completed, make sure to check

notes before operation.

"4.5 Notes Before Operating the Server"

For details about maintenance after operations have

started, refer to "User's Guide Chapter 8 Operation

and Maintenance".

- After optional devices are installed, set the BIOS

Setup Utility as required. For details about setting

procedures, refer to the "User's Guide Chapter 7

Configuring Hardware and Utilities".

- If an UPS device is installed, set the BIOS Setup

Utility as required. For details, refer to the "User's

Guide 4.5.3 Notes on Advanced Uninterruptible

Power Supply (UPS)".

When turning on the server again after turning it

off, wait for at least 10 seconds, and then press the

power switch.

If the server is turned on straight after being turned

off, an error will occur and may cause damage.

Support and service

l PRIMERGY information

For the latest information on PRIMERGY, update modules,

drivers and the software, refer to the Fujitsu PRIMERGY

website (http://primergy.fujitsu.com).

Regarding BIOS and firmware, contact an office listed in the

"Contact Information".

l Before requesting repairs

If an error occurs in this server, refer to "User's Guide 8.2

Troubleshooting".

If problems can still not be solved, contact an office listed in

the "Contact Information".

When contacting the office listed in the "Contact Informa-

tion", inform them of the product ID and manufactures num-

ber on a label attached to the server as shown below.

��

�

Also read the points to note about requesting repairs before-

hand in "User's Guide 8.8.1 Contacting Maintenance Sup-

port".

Print the "Configuration Sheets" - "Accident sheet" that

is available from Fujitsu PRIMERGY website (http://

primergy.fujitsu.com) and enter the confirmed information.

��