Fujitsu PRIMERGY TX300 S3 Panduan Suplemen Servis - Halaman 17
Jelajahi secara online atau unduh pdf Panduan Suplemen Servis untuk Server Fujitsu PRIMERGY TX300 S3. Fujitsu PRIMERGY TX300 S3 47 halaman.
Halaman Cetak
4
Replacement routines
V
CAUTION!
Observe the safety instructions in the
et seq. .
4.1
Preparation
4.1.1
Floorstand model
I
You will find a detailed description of 'Opening the server' and 'Removing
the front cover' in the Options Guide TX300 S3.
4.1.1.1
Opening the server
Ê Terminate all applications and shut down the server correctly.
Ê If your operating system has not switched off the sever, press the on/off
switch.
Ê Pull all power connectors out of the power outlets.
Ê If required, remove the lock on the side cover.
Ê Open the latch.
Ê Push back the left-hand side cover approxiate 2 cm.
Ê Remove the side cover.
4.1.1.2
Removing the front cover
Remove the front cover when making the following replacements:
– Replacing the operating panel
– Replacing the intrusion switches
Ê Open the server and remove the key.
Ê Push the drive cover up as far as possible.
Ê Remove the hard disk cover.
TX300 S3
chapter "Safety notes" on page 11
Service Supplement
17