Fujitsu SPARC Enterprise M5000 Panduan Tambahan - Halaman 21
Jelajahi secara online atau unduh pdf Panduan Tambahan untuk Server Fujitsu SPARC Enterprise M5000. Fujitsu SPARC Enterprise M5000 36 halaman. Rci build procedure
Juga untuk Fujitsu SPARC Enterprise M5000: Panduan Fitur (30 halaman), Catatan Produk (44 halaman), Panduan Memulai (4 halaman)
Halaman Cetak
1.2
RCI command
RCI commands are used to display RCI configuration information and set node
addresses.
To connect I/O units equipped with RCI ports, a setup using RCI commands is
required in addition to the connection with RCI cables.
Remarks: When you use the terminal function of the External power controller,
perform the setrcic command and confirm setting or connection of the
External power controller. For details of the setrcic command, see the RCI
User's Guide or man page.
1.2.1
Command list
The RCI commands are explained below.
Command
setrci -c stat
setrci -c init
setrci -c set [host_no] Sets up an RCI Host node.
setrci -c initconfig
setrci -c addconfig
C120-E361-04EN
Table 1.1 Command list
Displays RCI configuration information. This command
is used after the RCI setup to verify
that the settings of the host and I/O units have been made
correctly.
Initializes the RCI configuration information.
If other host units are connected through the RCI, the
RCI settings must be initialized on each host unit.
You can use this command if the system is powered off.
Before this command can be executed, the RCI settings
must already have been initialized.
host_noÅF Integer numbers from 1 to 32 are assigned
in this order.
Assigns an RCI address to an I/O unit connected via RCI.
Before this command can be executed, the RCI Host
node settings must already have been made.
Makes the RCI settings for the case that a host unit or an
I/O unit is added.
Function
1.2 RCI command
1-3