Fujitsu SPARC Enterprise M5000 Panduan Tambahan - Halaman 28
Jelajahi secara online atau unduh pdf Panduan Tambahan untuk Server Fujitsu SPARC Enterprise M5000. Fujitsu SPARC Enterprise M5000 36 halaman. Rci build procedure
Juga untuk Fujitsu SPARC Enterprise M5000: Panduan Fitur (30 halaman), Catatan Produk (44 halaman), Panduan Memulai (4 halaman)
Halaman Cetak
CHAPTER 1 RCI Build Procedure
XSCF> setrci -c set 2
The command completed successfully
7
Execute the setrci -c addconfig command on main unit B to expand the RCI
configuration.
XSCF> setrci -c addconfig
The command completed successfully
8
Display the RCI status by executing the setrci -c statcommand on main unit A.
XSCF> setrci -c stat
HOST
address 000102ff
Active
LIST
address pwr alm I/F sys-phase ctgry dev-cls sub-cls tm-out
000101ff OFF - ACT
000102ff OFF - ACT
003001ff OFF - ACT
003002ff OFF - ACT
The command completed successfully
9
Verify that the added main unit is incorporated.
1.3.5
Connection of RCI
According to the following procedure, connect different units with RCI cables by
using a daisy-chain connection.
1
Prepare RCI branching connectors and RCI terminating resistors.
All of them are supplied with the main unit.
2
Connect the main unit and I/O units with RCI cables (see
Figure
1.10.)
1
Connect the RCI branching connector (1) to the RCIport on an XSCF unit of the
main unit.
2
Connect the RCI branching connector and the RCI port of an I/O unit with an RCI
cable (2) by using a daisy-chain connection.
1-10
--
host 0001 0b
--
host 0001 0b
--
disk 0400 04
--
disk 0400 04
-
-
-
-
Figure 1.9
and
C120-E361-04EN