Fujitsu 6670 - fi - Document Scanner Panduan Pengguna - Halaman 22

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Pemindai Fujitsu 6670 - fi - Document Scanner. Fujitsu 6670 - fi - Document Scanner 26 halaman. Color duplex document scanners
Juga untuk Fujitsu 6670 - fi - Document Scanner: Brosur (2 halaman)

Halaman Cetak

1. Test-Scanning Documents

Test-Scanning Documents

Using ScandAll PRO, you can test-scan documents to check if they are scanned with the ADF correctly.

For how to scan documents with the flatbed, refer to "Chapter 5 Various Documents" in the Operator's

Guide.

The following describes how to test-scan a document:

Turn on the scanner.

1) Press the "I" side of the main power switch of the scanner.

2) Press the [Power] button on the Operator Panel.

The scanner is turned ON, and the Power LED on the Operator Panel lights in green.

Note that while the scanner is being initialized, the indication of the Function Number Display

changes as; "8"

Turn on your computer.

The scanner is automatically detected, and

the [Found New Hardware] dialog box

appears.

Select [Locate and install driver software

(recommended)] to install the driver,

following the on-screen instructions.

"P"

"1", where "1" means that the Operator Panel is in the Ready Status.

If you see an error indication other than the above on the Function Number Display, refer to "Chapter

8 Troubleshooting" in the Operator's Guide.

Ex. :If "U" is displayed on the Function Number Display, it means that the Transport Lock remains

locked. In such case, you need to unlock the Transport Lock.

For how to unlock the Transport Lock, refer to "Section 2 Installing the Scanner" (on page 12).

ADF type

Operator Panel

Function

Scan / Stop

Check

Send to

Function Number Display

For a SCSI connection, turn on the scanner and confirm that the Function Number Display shows "1."

Then, turn on your computer.

If the connection is made via SCSI Connector 2, there is no need to install the driver here.

Just select [Don't show this message again for this device].

Flatbed type

Power

[Power] button