Fujitsu FI-5900C Prosedur Instalasi

Jelajahi secara online atau unduh pdf Prosedur Instalasi untuk Pemindai Fujitsu FI-5900C. Fujitsu FI-5900C 3 halaman. Consumable replacement and cleaning instructions
Juga untuk Fujitsu FI-5900C: Memulai (30 halaman), Manual Prosedur Instalasi (7 halaman), Manual Prosedur Instalasi (9 halaman), Brosur & Spesifikasi (2 halaman), Panduan Tambahan (4 halaman), Memulai (30 halaman), Brosur & Spesifikasi (4 halaman), Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai (24 halaman), Prosedur Penggantian (22 halaman), Petunjuk Pembersihan (2 halaman)

Fujitsu SCSI (650) VRS

If you are installing the following models by means of the Kofax 650 Adrenaline SCSI

controller with/without a GSA-2 then use this document.

M4097D-VRS

Fi-5650C-VRS

If you do not have a 650 controller and are not going to use VRS then use the SCSI

scanner installation guide. If you are going to use the optional video interface then use

the video scanner installation guide. If you have an 850S/1700S controller and a GSA-1

interface then you must use the SCSI (GSA-1) VRS scanner installation guide.

Hardware requirements.

You will need a PC system that meets both Fujitsu's and Kofax's recommended

specifications, a Kofax 650 Adrenaline controller and six foot (maximum) Wide SCSI 68-

pin cable. For recommended PC system specifications and SCSI controllers please

reference the

Scanner Hardware Reference

System Disk.

Step A: Installing the VRS drivers.

First boot your PC and install the Kofax VRS driver that shipped with the scanner.

Special note: When installing the VRS driver and any other software that contains

Kofax's Image Controls pay close attention to the individual runtimes. It is strongly

recommended that you install the oldest/lower runtime application first.

Step B: Installing the Adrenaline 650 Adrenaline controller

1. Shut down your PC and remove the case cover.

2. Locate a free PCI slot and remove the back plate if necessary.

3. Install the SCSI controller in an open PCI slot. Make sure that the card is

seated completely in the slot and secured in the frame.

Warning! Failure to secure the SCSI controller in the PC can result in damage

to the SCSI card, scanner, and/or your system.

4. Boot your PC without the scanner attached and check for errors. Make sure

that the SCSI controller is listed as a 650 Adrenaline. If no errors proceed to

the next step.

Step C: Unlocking the shipping lock.

If your model scanner does not have a flatbed then proceed to Step D.

Rev052206A

Scanner Installation Procedures

Windows ME\2000\XP

M4099D-VRS

Fi-5750C-VRS

Fi-4860C-VRS

page. You may also need your Operating

Fi-4990C

Page 1 of 3