Fujitsu fi-6400 Memulai - Halaman 5

Jelajahi secara online atau unduh pdf Memulai untuk Pemindai Fujitsu fi-6400. Fujitsu fi-6400 6 halaman. Image scanner
Juga untuk Fujitsu fi-6400: Pengoperasian yang Nyaman (24 halaman)

Halaman Cetak

Make sure that the computer is turned

OFF.

Connect the scanner to your computer

either with a USB or SCSI cable. (fi-6800)

Only fi-6800 is supported by SCSI.

You cannot make both USB and

SCSI cable connections at the

same time. (fi-6800)

You cannot connect multiple

computers to the scanner at the

same time.

Turn off the scanner and your

computer whenever you switch the

interface cable.

The following describes the requirements for

connecting with the respective cables.

USB cable

-Be sure to use the USB cable which comes

as an accessory with this scanner.

-When connecting to an USB hub, use the

first stage USB hub that is closest to the

computer. If you use the second or later hub

stages, the scanner may not operate cor-

rectly.

-If you connect the scanner with USB 2.0, it

is required that the USB port and the hub be

compliant with USB 2.0. The scanning

speed slows down when you connect the

scanner with USB 1.1.

SCSI cable (fi-6800)

Be careful not to damage any pins of

the SCSI connector when connecting

the scanner to your computer.

-When using the scanner with a SCSI inter-

face, the following types of SCSI cable and

SCSI card must be purchased.

SCSI cable:

Use a SCSI cable whose connector on the

computer side mates to the connector on

the SCSI card installed on your computer.

On the scanner side, use a 50-pin high-

density type SCSI cable.

SCSI Connector 1: 50-pin high-density type

SCSI Connector 2: 68-pin high-density type

SCSI card:

Find the recommended SCSI card informa-

tion on the Fujitsu website (FAQ):

http://www.fujitsu.com/global/support/com-

puting/peripheral/scanners/scsi/

-In a SCSI daisy chain formation, connect

the scanner so that it is the terminated

device.

-The SCSI ID initially set at the factory is [5].

If the SCSI ID of another SCSI device is set

to the same ID, change the scanner's SCSI

ID to [0] through [6].

Connect the power cable to the power

connector of your scanner and to the

power outlet.

WARNING

Be sure to use the supplied power cable.

The following cases may cause electrical

shock or malfunction.

Using a power cable other than that

supplied

Using the supplied power cable for other

devices

Test-Scanning Documents

Using PaperStream Capture, you can test-scan

documents to check if they are scanned correctly.

The following describes how to test-scan a

document:

Turn on the scanner.

1. Press the "I" side of the main power switch on

the rear side of the scanner.

2. Press the power button on the front of the

scanner. The scanner is turned ON, the

power button lights in blue, and the liquid

crystal display (LCD) shows [Ready].

If you see an error indication other

than the above on the LCD, refer to

"Chapter 7 Troubleshooting" in the

Operator's Guide.

LCD

Function

/Enter

Send to

Clear

Check

Overlay

/Pause

/Back

Stop

Scan

Counter

iMFF

Reset

Eject

Power Button