Fujitsu fi-6670 Series Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai - Halaman 6

Jelajahi secara online atau unduh pdf Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai untuk Pemindai Fujitsu fi-6670 Series. Fujitsu fi-6670 Series 22 halaman. Image scanner
Juga untuk Fujitsu fi-6670 Series: Panduan Pengguna (26 halaman), Manual Prosedur Instalasi (6 halaman), Brosur (2 halaman), Spesifikasi (2 halaman), Panduan Memulai (14 halaman), Panduan Memulai (26 halaman)

Halaman Cetak
Fujitsu fi-6670 Series Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai
fi-6670(A) & fi-6770(A) C
6
R
ONSUMABLE
EPLACEMENT AND
R
EPLACING THE
Worn out, defective, or improperly installed Pick Rollers will cause mis-
feeds and paper jams. The Pick Rollers have an approximate life of
250,000 pages. If NCR or carbonless paper is scanned, the life span of
the Pick Rollers will be decreased by as much as 50%.
Note:
It is very strongly recommended to replace the Brake Roller and Pick
Roller at the same time. This will insure the longest possible life for
each consumable item.
If the Brake Roller and Pick Roller have been cleaned (refer to the cleaning
section of this document) they should be replaced if the scanner continues
to multi-feed or jam paper at a high rate.
•
Remove any documents
remaining in the ADF Paper
Chute.
•
Press the ADF Buttons to
release the lock and open the
ADF.
•
Slide open the Sheet Guides
on the Paper Chute, making
sure that they do not obstruct
the Pick Roller Cover.
•
Open the Pick Roller Cover.
•
Slide the two Pick Rollers in
the direction of the arrow and
lift them out of the scanner.
Note:
The Pick Rollers are made
up of two rollers. The roller
with the treads going across
the roller is the Separation
Roller. The roller with the
belt in the center is the Pick
Roller.
C
I
LEANING
NSTRUCTIONS
P
R
ICK
OLLERS
ADF Buttons
Pick Roller
Separation Roller