Fujitsu M3093EX Panduan Operator - Halaman 40

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemindai Fujitsu M3093EX. Fujitsu M3093EX 50 halaman. Departmental document scanner
Juga untuk Fujitsu M3093EX: Brosur (2 halaman), Prosedur Instalasi (3 halaman), Brosur & Spesifikasi (2 halaman), Panduan Petunjuk Pembersihan (12 halaman)

Halaman Cetak

APPENDIX B

B.1 Test mode for maintenance

CAUTION: Please follow the procedure here or the offset data may be changed incor-

rectly. If the scanner does not react as the procedure below, turn off the

scanner and start from the beginning.

(1) Activating a test mode

Open the ADF cover and set the sensors to the following state before turning on the image

scanner. The image scanner can be placed in the maintenance mode by pulling out the

empty sensor lever and setting the B5 size sensor lever to down position with the ADF

cover fully opened (see Figure below). If the image scanner is placed in the maintenance

mode, the POWER lamp blinks. If the POWER lamp does not blink, turn off the power

and try again. Then close the ADF.

(Setting of the ADF sensors for maintenance mode)

- Empty sensor: UP

- B5 size sensor: DOWN

B5 Size sensor

Empty sensor

ADF open

DOWN

B – 1