Fujitsu M3093GX Panduan Operator - Halaman 37

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemindai Fujitsu M3093GX. Fujitsu M3093GX 50 halaman. Departmental document scanner
Juga untuk Fujitsu M3093GX: Manual Prosedur Instalasi (7 halaman), Manual Prosedur Instalasi (9 halaman), Brosur & Spesifikasi (2 halaman), Panduan Petunjuk Pembersihan (12 halaman), Prosedur Instalasi (5 halaman)

Halaman Cetak
Fujitsu M3093GX Panduan Operator
Problem
Possible cause
The check
The carrier fixing bracket
indicator is on.
was not removed.
——————————
"Check" lamp
The pick roller is dirty.
blinks at 4
seconds period.
The unallowable document
was read in the automatic
document feeder.
(See Section 4.3.)
Paper double feed.
Pad is dirty.
Pad is worn out.
Miss pick.
Pick roller is dirty.
Pick roller is worn out.
Paper jam.
Some foreign particles are in
ADF.
* Please check the test mode in appendix B, if possible, before calling the service representa-
tive and inform status of the indicators.
6 – 2
Table 6.1 Check items (continued)
Response
Remove the carrier fixing bracket as
explained in Section 3.2, "Removing the
Carrier Fixing Bracket."
Turn the power off then on again. If the
check indicator turns on again, contact the
sales person in charge or a Fujitsu service
representative.*
When the power is turned off, the mes-
sage is cleared.
Even if the message is displayed, the read
operation can be continued. Clean the
pick roller after the read operation.
(See Section 5.3.2.)
If a document not meeting the scanner
specifications is read in the automatic
document feeder, the document is not fed
smoothly and an error message may be
displayed.
Read the document in the flat bed station.
Clean the Pad. (See Section 5.3.2)
Replace the Pad. (See Section 5.4.2)
Clean the Pick roller. (See Section 5.3.2)
Replace the Pick roller.
(See Section 5.4.3)
Clean the ADF (See Section 5.3.2) or
remove any foreign particles.