Fujitsu M3093GX Panduan Operator - Halaman 41

Jelajahi secara online atau unduh pdf Panduan Operator untuk Pemindai Fujitsu M3093GX. Fujitsu M3093GX 50 halaman. Departmental document scanner
Juga untuk Fujitsu M3093GX: Manual Prosedur Instalasi (7 halaman), Manual Prosedur Instalasi (9 halaman), Brosur & Spesifikasi (2 halaman), Panduan Petunjuk Pembersihan (12 halaman), Prosedur Instalasi (5 halaman)

(2) Activating the continuous operation test

Open the ADF and close it again. If no document is loaded on the ADF within five sec-

onds after closing the ADF, the image scanner runs in flatbed mode. If documents are

loaded on the ADF within five seconds after closing the ADF, the image scanner continu-

ously feeds the document from ADF. Once the image scanner start reading documents in

the flatbed mode, it does not feed documents from ADF even if documents are loaded on

the ADF.

(3) Ending the test in flatbed mode

To stop the carrier movement in flatbed mode, open the ADF cover. If the ADF cover is

opened, the POWER lamp starts blinking immediately after the carrier returns to the home

position.

(4) Ending the test in ADF mode

If the ADF document hopper is empty, feeding documents from the ADF ends. To restart

feeding, open the ADF cover and close it again. Then load documents on the ADF docu-

ment hopper within five seconds after closing the ADF cover.

(5) LED status on error

If an error occurs during the test, the LED indicates as shown in table B.1.

If paper is jammed in the ADF, remove the jam and close the ADF cover. The CHECK

lamp stops blinking about three seconds after closing the ADF cover. To feed the docu-

ment from ADF, open and close the ADF cover.

Errors

Paper jam

Carrier unit error

Optical system error

Motor fuse failure

Lamp fuse failure

B – 2

Table B.1 LED at an error

POWER lamp

Blink

READ lamp

CHECK lamp

Off

Blink