Fujitsu M4097D - Fb 50PPM SCSI A3 Dupl 100Sht Adf Prosedur Instalasi - Halaman 2

Jelajahi secara online atau unduh pdf Prosedur Instalasi untuk Pemindai Fujitsu M4097D - Fb 50PPM SCSI A3 Dupl 100Sht Adf. Fujitsu M4097D - Fb 50PPM SCSI A3 Dupl 100Sht Adf 3 halaman. Image scanner
Juga untuk Fujitsu M4097D - Fb 50PPM SCSI A3 Dupl 100Sht Adf: Manual Prosedur Instalasi (7 halaman), Manual Prosedur Instalasi (9 halaman), Brosur (2 halaman), Prosedur Instalasi (3 halaman), Prosedur Instalasi (3 halaman), Brosur & Spesifikasi (2 halaman), Brosur & Spesifikasi (2 halaman), Katalog Suku Cadang Bergambar (22 halaman), Prosedur Instalasi (5 halaman)

Fujitsu SCSI

Scanner Installation Procedures with

The M4097D has the "L" bracket shipping lock.

1. Slide the scanner to its side as shown in figure below.

2. Unscrew the retainer screw and remove the shipping bracket.

3. Place the shipping bracket in the "use position" slot and secure it with the

retainer screw (see figure below)

4. Place scanner back in its normal position

Step D: Connecting the Scanner.

Warning! Before proceeding ensure that the power is off when connecting or

disconnecting the SCSI cable to the scanner or workstation. Failure to follow the

procedure above could result in damage to the SCSI card, scanner, and/or your system.

Termination and the SCSI ID's for both the M4097D and M4099D VRS

scanners are handled automatically. Connect the SCSI cable to the Kofax

controller and to the Wide SCSI (68-pin) port on the scanner. Ensure all

connections are securely fastened.

Connect the power cord to the scanner and a wall outlet. Boot up the host PC

first and then turn on the scanner. Listen to and watch the back of the

Rev010807L

Windows 2000 / XP

VRS (GSA-1)

Page 2 of 3