Fujitsu ScanSnap iX1600 Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai - Halaman 18

Jelajahi secara online atau unduh pdf Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai untuk Pemindai Fujitsu ScanSnap iX1600. Fujitsu ScanSnap iX1600 22 halaman.

Halaman Cetak
Fujitsu ScanSnap iX1600 Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai
(3) Rotate the bushing on the Pick-Roller-ASSY in the direction of the arrow (see the lower left figure).
(4) Gently lift the right side of the bushing (about 5 mm) (①), move it towards the right, and then pull it out. (②)
Notice
Be careful not to touch the gear near the bushing as it contains grease.
Installation
(1) Insert the left end of the shaft into the slot (①), and lower the other end gradually (②).
(2) Rotate the bushing on the Pick-Roller-ASSY in the direction of the arrow (see the lower right figure).
ATTENTION
Confirm that the pick rollers are installed properly. Otherwise, paper jams or other feeding errors may occur.