Fujitsu ScanSnap iX1600 Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai - Halaman 6
Jelajahi secara online atau unduh pdf Petunjuk Penggantian dan Pembersihan Bahan Habis Pakai untuk Pemindai Fujitsu ScanSnap iX1600. Fujitsu ScanSnap iX1600 22 halaman.
Halaman Cetak
7. Feed-Roller (x2)
8. Exit-Roller (x2)
Gently wipe the dirt and dust off while taking care not to damage the surface of the rollers. Make sure that
they are cleaned properly because residue on the rollers will affect the feeding performance.
(12) Close the ADF top section.
Cleaning the Inside of the Scanner
iX1400
Clean the inside of the ScanSnap regularly.
Scanning repeatedly accumulates dust and paper dust inside the ScanSnap, and this may result in an error during a scan.
As a guideline, the inside of the ScanSnap should be cleaned every 1,000 sheets scanned.
Note that this guideline varies depending on the types of documents you scan. For instance, it may be necessary to clean
the scanner more frequently when you scan documents on which the toner is not sufficiently fused.
Notice
-
The bottom part of the ScanSnap may become hot when the ScanSnap is being used but this does not affect
ScanSnap operation or cause any physical harm. Be careful not to drop the ScanSnap when carrying it.
-
Do not use water or mild detergent to clean the inside of the ScanSnap.
-
It may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the cloth with a moderate
quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
Cleaning Procedure
(1) Unplug the power cable from the ScanSnap.
(2) Remove any documents from the ADF paper chuter (cover).
(3) Remove the Receipt Guide from the scanner when it is attached.