Fujitsu DISK DRIVES MHL2300AT Panduan Pemeliharaan - Halaman 27
Jelajahi secara online atau unduh pdf Panduan Pemeliharaan untuk Penyimpanan Fujitsu DISK DRIVES MHL2300AT. Fujitsu DISK DRIVES MHL2300AT 30 halaman.
Halaman Cetak
2.2 Disk Drive Removal
2.1 Spare Parts
See Table 2.1 for the model and parts numbers to order the replacement disk
drive.
Model
MHL2300AT
MHM2200AT
MHM2150AT
MHM2100AT
2.2 Disk Drive Removal
The method and procedures to demount the disk drive to check the jumper
terminal, change the jumper position, or replace the device differ depend on the
system cabinet structure. Therefore, for actual working procedures, the specific
conditions necessary for each system must be determined. The general removal
procedures, with notes, is as follows.
a) Disconnect the power-interface cable.
b) Remove the screws that attach the drive and remove the drive from the
system cabinet.
c) When storing or transporting the drive, pack it an antistatic bag.
To protect the device from damage and prevent the worker getting hurt, observe
the following cautions and precautions in Subsection 1.1.1.
1.
2.
3.
2-2
Table 2.1 Model and parts numbers
Part number
Formatted
capacity
CA05428-B060
CA05429-B040
CA05429-B030
CA05429-B020
Perform any removal after the system power is completely
disconnected. The cable must not be disconnected and the
screws that attach the drive must not be removed with the
power ON.
Do not move the drive until it comes to a complete stop (about
30 s after the power is turned OFF).
Perform the human body grounding to discharge any static
electricity from your body. (Be sure to wear a wrist strap)
Removal and Replacement Procedure
Mounting screw
30 GB
20 GB
M3 (depth 3)
15 GB
10 GB